(adsbygoogle = window.adsbygoogle || []).push({}); Hi..
My PS3 will not output with my component cables..
Whenever I press change I get a black screen for 30 seconds..
Then it turns back..
YES I've tried a video reset..
I have an iMac 2011 and a Slim PS3...
Also a Philips TV of some model..
50k vBux reward for the person who fixes the problem...

i had to call ps once for this you need to go into recovery mode and reset your whole ps3 i think

Maybe next time you should post in the right section.

wit nvm im dum b didnt read properly

were you using hdmi before? if so component is usually on a different input for your tv.

if you get picture on your tv until your pvr is pulled up on your computer check the box on the left where it shows how its connected. one time mine got switched to SD and my tv would black screen as soon as i turned my pc on.

No.. But they are all correct.. It was working until yesterday when i started up MW2.. All of a sudden my ps3 won't work and the component cables don't work. This happened before but i forget how i fixed it..
And yes my components are on the right input channel...

USE HDMI first, set it to 720p. After that switch back to component cables again. You have to turn ON the HD PVR first before turning on the Ps3.

Use 720p for component cables for optimum display settings.

[QUOTE='[F]ried [R]ice;3857693']USE HDMI first, set it to 720p. After that switch back to component cables again. You have to turn ON the HD PVR first before turning on the Ps3.

Use 720p for component cables for optimum display settings.[/QUOTE]

Done... No luck..
I did this at 1080i..
Should produce the same result right?
(Yes my TV supports 1080i)

wait no i was right cyou do need to reset your whole ps3 in recovery mode bcz it is set to hdmi cable or you can put ur hdmi cable in and change it to sd cables

[QUOTE='[F]ried [R]ice;3857693']USE HDMI first, set it to 720p. After that switch back to component cables again. You have to turn ON the HD PVR first before turning on the Ps3.

Use 720p for component cables for optimum display settings.[/QUOTE]

Done... No luck..
I did this at 1080i..
Should produce the same result right?
(Yes my TV supports 1080i)

---------- Post added at 02:47 PM ---------- Previous post was at 02:44 PM ----------



Don't want SD cables?
Components are HD