Post: 250GB WD - PS3 Harddisk - Guide -
06-02-2008, 05:49 PM #1
N00B
Do a barrel roll!
(adsbygoogle = window.adsbygoogle || []).push({}); i'd prefer to make this topic STICKY

remember the future of ps3 coming soon this year, u really need to get ready for higher capacity for more incoming games that install itself into H.D ... especially MMORPGS

You must login or register to view this content.

Guide how to Install new hard drive in your PS3

Compatible hard drives need to meet these specifications:

* 2.5" form (generally refered to as a notebook drive)
* Serial ATA interface, also shown as SATA
* 9.5mm Height


Removing the hard disk

1. Touch the power button on the system front for at least two seconds.

The power indicator will turn solid red and the system will enter standby mode.

2. Turn off the system using the main power switch on the system rear.

3. Unplug the AC power cord and detach the other cables from
the system.

For safety reasons, remove the plug for the power cord from the electrical outlet,
and then detach the other cables.

You must login or register to view this content.

Remove the HDD bay cover on the system's left side.

You must login or register to view this content.

You must login or register to view this content.

Use the space at the right edge of the HDD bay cover to pull it out from the system.

If the cover is difficult to remove, gently insert a
small screwdriver in the space and pry the cover off. Be careful not to damage the system or the cover when using a screwdriver.

Free the hard disk from the system.

Remove the blue screw with a crosshead screwdriver.

You must login or register to view this content.

Raise the metal handle.

Slide the hard disk to the right.

You must login or register to view this content.

You must login or register to view this content.

You must login or register to view this content.


Remove the hard disk from the system.

You must login or register to view this content.

Use the metal handle to pull the hard disk out from the system.

Replacing the hard disk
When replacing the hard disk, follow the procedure below to remove the metal frame.
You must login or register to view this content.

Use a crosshead screwdriver to remove the screws (4 places).
These screws are very tight, be sure to find a screwdriver that fits very well, and take your time.
If you strip a screw head and want to purchase a replacement screw see the bottom of this post.

You must login or register to view this content.

You must login or register to view this content.

Remove the hard disk from the metal frame.
Lift one end and slide the hard disk out to remove.

You must login or register to view this content.

Place the replacement hard disk on the PS3? system hard disk's metal frame, and then attach using the screws (4 places).
Do not overtighten the screws.

Install the hard disk in the system.
Fully insert the hard disk in the HDD bay, and then slide it to the left. (I find that using your finger works better than the wire for this)

You must login or register to view this content.


Attach the blue screw to lock the hard disk in place.
Reattach the HDD bay cover.

Turn on the PS3? system. and congratulations for ur new 250GB Playstation 3 Smile^

The following 3 users say thank you to N00B for this useful post:

deon, JAM-games, trickzz
11-09-2008, 06:36 PM #38
bigd321
Save Point
nice thread where do you buy a replacement screw if you strip one of the oters
11-10-2008, 01:35 AM #39
Boneho
Do a barrel roll!
Thanks man i just bought a 120 gb harddrive from ebay You must login or register to view this content.
and ill be upgading my old 40gb. Also one question how do i save everything i have in my ps3 40gb harddrive and transfer it to the 120 gb one?
11-10-2008, 05:43 PM #40
Sert
Al Capone, Jr.
Update: Installed 250 mb hdd w/ 7200 rpm and a 16 cache and it works great! Installation was very simple, backing up took longer than install. Playing cod4 this weekend I could notice a small amount of extra speed, but it was more noticeable in Bioshock. Get the 7200 rpm
11-10-2008, 07:53 PM #41
BTBrepresenta
Do a barrel roll!
Originally posted by Insertion View Post
Update: Installed 250 mb hdd w/ 7200 rpm and a 16 cache and it works great! Installation was very simple, backing up took longer than install. Playing cod4 this weekend I could notice a small amount of extra speed, but it was more noticeable in Bioshock. Get the 7200 rpm


I agree homie..
12-07-2008, 10:56 AM #42
Reece
Gobble
Really good forum you got here...but I was just wondering, because I want to upgrade my PS3:

Would it be possible to use a 500GB Samsung 2.5 inch Hard Disk Drive 5400rpm SATA 8MB. Here is the link: You must login or register to view this content.
12-07-2008, 11:06 AM #43
Don't you have to back up all your files first?
12-07-2008, 11:20 AM #44
Reece
Gobble
Yes, that won't take me long, I just want to know if that 500GB hdd would work, cos if so I want to buy it asap.
12-09-2008, 05:03 PM #45
it will work in any model and will not void manufactures warenty i would recomend the samsung 350gb notebook hd retail 75.00$
12-09-2008, 06:12 PM #46
joeay
Pokemon Trainer
What can i use to back up all my files other than a external hard drive? isnt there a way to connect it to my computer or something?

Copyright © 2024, NextGenUpdate.
All Rights Reserved.

Gray NextGenUpdate Logo