(adsbygoogle = window.adsbygoogle || []).push({}); Usb-Powered e3 Flasher - Get Backups from dead Ps3s



Im going to show you how to make your e3 flasher usb powered (or power by plugin).
Why would you want to do this? We don't always have the opportunity to keep a
ps3 running, and that is usually needed in order to extract a cid from your
most dead of ps3s. This will not harm your e3 flasher if the instructions are
followed, but the risk is yours to take.







You're going to need:
e3 flasher
wire
Soldering iron
a usb cable (one that you are willing to cut up) |Alternatively you can use a wall plugin. Most phone chargers etc can supply the 4-5v we need|
tape

1. Let's start with the e3 flasher
On the bottom of the flasher it should look like this

You must login or register to view this content.


2. cut two 4-5inch pieces of small wire (one black and one red?)

3. You want to solder one wire to positive and one to negative

You must login or register to view this content.


should look like so:

You must login or register to view this content.


4. Tape over it to prevent shorting

You must login or register to view this content.



You must login or register to view this content.




5. Cut one end of the usb cable off and expose the two wires
*If there are more than two wires, tape them all to the side, leave red and black, or whatever + and - is for you
Hopefully(in most cases, it will be easy to destinguish which of the two wires is + or -, but if not
you will have to test with a multimeter.*

6. connect red+ to red+ and blk- to blk- from the new wires on the e3 flasher, to your usb cable


You must login or register to view this content.

7. Plug the usb into your PC (most if not all will supply 5v, the max amount to power your e3 flasher)
Less than 3v will not power it enough to get a backup
Do not use over 5v it is the max



You must login or register to view this content.




Part 2
Extracting a NOR chip to get a backup(retrieve a CID) from a completely dead Ps3


What you will need:
externally powered e3 flasher
heat gun
Access to NOR chip



1. Strip the ps3 to the motherboard

2. Locate your NOR chip

3. use your heat gun to blast directly at the NOR chip until you can EASILY slide the chip away

So now you got one or some of these

You must login or register to view this content.


4. Once you have the chip, it is just a matter of squeezing the chip into your usb powered e3 flasher's clip
and going about it as you normally would get a backup
* e3 flasher's lights should shine very bright. If the e3 flasher's lights are dim, you have the chip in backwards.


Hope it helps !

You can extend the wires if you want...that's up to you.

Otherwise, yea. If those are confirmed your positive and negative, match red to red and black to black.

there not comfermied as don't have a cheacker

I gotcha. It should be alright.

good luck
Need any more help, just ask.